ACCC guy grip LJS
Performed dead end guy grip, LJS were developed to grip the ACC or ACCC conductor while construction of electrical transmission network lines on wood poles or concrete towers, as analog of classical guying clamps.
Helical wire guy grip, LJS are made of high strength corrosion resistant aluminum alloy wire, covered by sand layer and glue, can be used in any environments. Aluminum deadends were designed to hold the full rated strength of aluminum (ACC), or aluminum alloy (ACCC) conductors.
Usually installed on conductor, do not require any tools.
Overhead aluminum dead end LJS do not require and protective rods or side splices, it can be installed straight on the electrical conductor.
The configuration of ACCC preformed clamp is calculated in order to minimize the failure and withhold full rated strength. In addition, our company has researched plenty of varieties of aluminum tension grips that is why we are able to match our cable guy grip or dead eads to your aluminum conductor size.
Conductor diameter, mm
Thimble, may be applied on tension load
If the required conductor size is missed in following chart, Jera preform line is capable to adjust ACCC performed in accordance to specification of conductor or develop new product for exact diameter and rated load in 7 days.
Our entire spiral formed wire products have been tested and verified in order to satisfy the requirements of our customers.
Jera preformed has the complete range of test equipment to proceed the type test of helical line products, preformed guy grip dead ends.
We focus on the quality and complete range of steel formed guy grips, which includes: ADSS distribution dead ends,Strand guy grips, suspension grips, galvanised steel side tie, drop wire dead ends, twin ties, insulator top ties, armor rods, full tension splices, thimbles, pole fittings (anchor shackles, ball eye), Formed Wire Accessories, motion control damper etc.
Welcome to contact us