Holding tool for insulation piercing connectors JTN-7 either called IPC installation tool，is a device to hold insulation piercing connectors through its installation. JTN-7 tool is designed for correct installation, where the position of cable is important to provide the required functioning of system: connector - cable. The tool us dielectric, made of a durable material.
Application
Holding tool JTN-7 is designed for holding the IPC, during LV ABC cable deployment in of low voltage overhead cable grids, up to 1 KV. Mainly with power cables, overhead and outdoor connecting systems, street lighting, cable wires.
Technical specification
Product code
Application
Dielectric strength
JTN-7
Low voltage insulation piercing connectors: models
1000V
Components and materials
Holding tool JTN-7, produced by Jera Line’s direct factory. The clamp consists of following main parts:
Components
Materials
Shaft mechanism
Stainless steel, brass
Body
UV resistant, fiberglass reinforced polymer
Moving clamp
UV resistant, fiberglass reinforced polymer
IPC holder
Aluminum
Dimensions
Key Installation steps
1.Unscrew the handle to fit the chosen LV insulation piercing connector (LV IPC).
2.Locate the LV IPC in the holding tool.
3.Gradually twist the hand until its proper holding of connector.
4.Locate the IPC with tool in perpendicular (mandatory) to main cable.
5.Use the tool by one hand and torque wrench by other hand to provide the convenience of installation.
6.When tightening the torque nut of IPC, do not rotate the IPC in any direction to the cable, except perpendicular. Keep it in this position.
.png)
